Actually you are there You just need to put the sheet 1 and sheet 2 into the SAME container on the dash
You had them is separate containers
Let me know if that worked
example floating sheets ML - 2.twbx 992.3 KB
sorry, I'm not very practice with containers and move sheets. Could you show or explain me how shoud I do?
Did you just remove Sheet2 from dashboard in your attached worksheet? I need both sheets, and show only one at time (based on parameter "Select a sheet")
Here is your dashboard now
There are 2 large containers - the one on the top is holding your blank sheet - the one on the bottom (green) has your tree chart
At the top of the Green container in the center is a couple of rows of dots - that is the handle - hover over it and drag it over the the upper container -
now the view looks like this
But both sheets are now in the upper container -
All you need to do now is go back to the lower container and grab the handle again and drag it off the view
now the view will look like this
You can now switch sheets with your filter on the top
Let me know if you have any other questions
One container solution may have some drifting effect when swapping.
Here is a solution using multiple overlapping containers, without drifting.