-
1. Re: TabJolt
Jeff StraussJan 10, 2018 8:37 AM (in response to Srikanth Maddela)
Hi Srikanth. Are you sure that you're using tabjolt for the right purpose? If so, it's fine, but I want to verify because I think of it differently. I think of tabjolt as a utility to run on an infrequent basis during the planning / design / tuning / sizing of your deployment and it's used to measure available capacity by running a load test that creates simulated concurrent user load. Typically we run tabjolt maybe twice a year as part of our upgrade cycle in order to measure if there is any massive change in capacity that we may need to react. Have you looked at the built-in admin stat reports that show performance numbers, or have you looked at tabmon yet which is able to capture more detailed performance?
-
2. Re: TabJolt
Srikanth Maddela Jan 10, 2018 8:42 AM (in response to Jeff Strauss)Jeff,
Thanks for the quick response. Yes we looked into TabMon as well. Do you think the above requirement is possible by TabJolt ?
-
-
4. Re: TabJolt
Srikanth Maddela Jan 10, 2018 8:50 AM (in response to Jeff Strauss)Jeff,
In brief, our approach is whenever user run the workbook , some times it is taking 5minutes and for the 2nd run it is taking more than 5 minutes. So here we are trying to capture that in an trend analysis form like at what time it taking 5 minutes and at what time it is taking more than that
-
5. Re: TabJolt
Jeff StraussJan 10, 2018 8:58 AM (in response to Srikanth Maddela)
Yep. The stats for load times can show trends, have you looked at it yet?
Here's an example from my on-premise deployment.
Also, if you are experiencing 5 minute rendering typically, then this is way too long. You should have a look at the performance recording to see what is going astray. Create a Performance Recording . If it's enabled for your server, all you have to do is add ?:record_performance-yes to the end of your URL. And it will generate a performance recording workbook that shows the time durations for each phase of rendering.
-
6. Re: TabJolt
Srikanth Maddela Jan 10, 2018 9:41 AM (in response to Jeff Strauss)this is the specific requirement to show all the detail records and it usually around 300k to 500k records with 70 columns ( tableaular report). Tableau does take some to prepare lay-out and later it is downloaded to CSV.
It is know that tableau will take time for this scenario but still I would like to know is there any way to improve this performance ?
-
7. Re: TabJolt
Jeff StraussJan 10, 2018 9:47 AM (in response to Srikanth Maddela)
If the requirement is inflexible, then there may not be anyway to improve, just because what you explain is more so a data dump, and Tableau is really good at providing visual dashboards to make metrics jump off of the page. You can have a look at "best practices" for more info.
Best Practices for Effective Dashboards
-
8. Re: TabJolt
Srikanth Maddela Jan 10, 2018 11:31 AM (in response to Jeff Strauss)Hi Jeff,
Can we enable Tab jolt in Task Scheduler that runs per hour ?
-
9. Re: TabJolt
Toby ErksonJan 10, 2018 12:13 PM (in response to Srikanth Maddela)
Specifically as to what Tabjolt is:
TabJolt is a “point-and-run” load and performance testing tool.
Tabjolt: The introduction, please read it.
Some help for Tabmon, what you probably need to be using:
-