3 Replies Latest reply on Dec 9, 2016 12:55 AM by Kenneth Li

    Map and table are not sync on filter

    Kenneth Li

      Hi,

       

      I have a map and a bar chart, I did a table calculation on the bar chart to find the percentage to total. Then I used a parameter method to make a global filter (ref:Create a global filter in Tableau across multiple data sources in eight simple steps /Problem using Table Calc as a Global filter )

      After that, I found the map and the bar chart are not sync in terms of the data shown.

      I have 10 countries on the chart but only 2 visible on the map......

      I checked the calculated value of two sheets, they are different...but how can I make them the same? The map shouldn't have any specific dimension that will filter the table cal.

      For reference: I used a calculated field for table cal. instead on configuring on the sheet. (formula: sum(value)/total(sum(value)))

      Thanks...

      Kenneth