1 Reply Latest reply on Dec 7, 2013 10:53 PM by Richard Leeke

    heat map based upon measurements with lat and long

    Corbett Kull

      I am trying to create a heat map where the bins of the heat map are based upon latitude and longitude.  Ideally, I would have bins for the heat map that are approximately 20 feet by 20 feet, but I can adjust that later. I then have a value that I want to accumulate based upon another measurement.  Each measurement will have an associated lat and long.  Depending on which bin it falls in, I want to contribute the measurement to that bin. 

       

      I should note the geographic area this will cover will be an area less than one square mile.