1 Reply Latest reply on May 2, 2012 12:34 PM by Tracy Rodgers

What MDX do I use to pull of a Dimensions values into a calculated measure

candace hill May 1, 2012 8:55 AM

I am trying to create a Parameter from 4 dimensions in an Analysis Services Cube. I created the calcualted measure, but it does not pull any values in. Is there an MDX functin that will specify to pull in all the values? Is there a resource to find the info on-line?

Thanks

1. Re: What MDX do I use to pull of a Dimensions values into a calculated measure

Tracy Rodgers May 2, 2012 12:34 PM (in response to candace hill)

Hi Candace,

Hard to say what exactly is going on without being able to see the workbook. However, if you haven't already seen this KB article, it might provide some insight:

http://kb.tableausoftware.com/articles/knowledgebase/functional-differences-olap-relational

-Tracy
Like Show 0 Likes(0)

Actions

Tableau Community Forums

What MDX do I use to pull of a Dimensions values into a calculated measure

1. Re: What MDX do I use to pull of a Dimensions values into a calculated measure

Actions

More Like This