2 of 2 people found this helpful
I took a look at your dashboard actions and there are two parts to change. First, on your Filter1 action (not the generated one, but the one you created), change that to "Clearing the selection will" > "Show All Values". Right now it's set to leave the filter in place.
Then, on your Filter2 action (again, the one you created, not the generated one), change the "Run action on" option to "Select" and change the "Clearing the selection will" again to "Show All Values".
I believe that after you make these two changes it'll give you what you're looking for.
Let me know if you have any questions.
1 of 1 people found this helpful
I think the issue is with one of your action filters
Filter 1 is set to leave in place on exit - change as shown below
If this posts assists in resolving the question, please mark it helpful or as the 'correct answer' if it resolves the question. This will help other users find the same answer/resolution. Thank you.
Hi Paul. Thanks for the response. I tried doing what you suggested and there is still an issue, as it reverts back to how it was originally, with all of the filters showing. I've attached what I mean
Thank you for your response. The issue with this is that my graph on the right reverts back to how it was with the filter initially, which I wanted to leave as it was. I have attached what I mean below.